This is an initial commit removing the excess capacitors.
We will eventually add ESD protection ICs in the space that has been
freed up.
Signed-off-by: Sean Cross <sean@xobs.io>
Reduce the ground fill under the IC, to prevent it from sliding around.
This gives less copper, but it should be fine for the currents we're
drawing.
Loosen up the routing of the 5V plane, which involves moving some
components around. This increases the amount of copper that goes to the
various regulators.
Finally, reorder the caps so that the larger ones are further from the
IC. This is done because they have a slower response time, and so can
be further away.
Signed-off-by: Sean Cross <sean@xobs.io>
Move some vias around to get the 5V plane more breathing room. Add a
small pour to give more copper and stabilize the net.
Signed-off-by: Sean Cross <sean@xobs.io>
Add more 5V vias near the 1.2V regulator, and replace a manual trace
with a copper pour. This will increase the amount of copper going to
both the 3.3V and 1.2V regulators, which should improve stability.
While we're at it, remove an errant silk artifact on the USB connector.
Signed-off-by: Sean Cross <sean@xobs.io>
Add a note indicating the PCB thickness and color.
Also, move the drill origin to the lower-left corner, to aid in machine
assembly.
Signed-off-by: Sean Cross <sean@xobs.io>
Add more silk, indicating website and other info.
While we're at it, move some traces around to give more copper area, and
drop some more vias to improve ground performance.
Signed-off-by: Sean Cross <sean@xobs.io>
