#!/bin/sh led_1=19 led_2=13 led_3=6 led_4=5 led_5=0 all_off() { gpio -g write ${led_1} 0 gpio -g write ${led_2} 0 gpio -g write ${led_3} 0 gpio -g write ${led_4} 0 gpio -g write ${led_5} 0 } green_on() { all_off gpio -g write ${green_led} 1 } yellow_on() { all_off gpio -g write ${yellow_led} 1 } red_on() { all_off gpio -g write ${red_led} 1 } red_also_on() { gpio -g write ${red_led} 1 } led_on() { case $1 in 1) gpio -g write ${led_1} on ;; 2) gpio -g write ${led_2} on ;; 3) gpio -g write ${led_3} on ;; 4) gpio -g write ${led_4} on ;; 5) gpio -g write ${led_5} on ;; esac } led_off() { case $1 in 1) gpio -g write ${led_1} off ;; 2) gpio -g write ${led_2} off ;; 3) gpio -g write ${led_3} off ;; 4) gpio -g write ${led_4} off ;; 5) gpio -g write ${led_5} off ;; esac } gpio_setup() { gpio -g mode ${led_1} out gpio -g mode ${led_2} out gpio -g mode ${led_3} out gpio -g mode ${led_4} out gpio -g mode ${led_5} out all_off led_on 5 } fail_test() { case $1 in load-tester-bitstream) ;; run-all-tests) led_on 2 ;; validate-spi) led_on 3 ; led_on 4 ;; test-spi) led_on 3 ;; test-rgbg) led_on 2 ; led_on 3 ;; test-rgbb) led_on 2 ; led_on 3 ;; test-rgbr) led_on 2 ; led_on 3 ;; test-touch) led_on 3 ; led_on 4 ;; load-final-bitstream) led_on 4 ;; verify-final-bitstream) led_on 4 ;; esac } gpio_setup echo "HELLO bash-ltc-jig 1.0" while read line do if echo "${line}" | grep -iq '^start' then all_off failures=0 elif echo "${line}" | grep -iq '^fail' then if [ $failures -ne 1 ] then failures=1 fail_test $(echo "${line}" | awk '{print $2}') fi led_on 1 elif echo "${line}" | grep -iq '^finish' then led_on 5 result=$(echo ${line} | awk '{print $3}') if [ ${result} -ge 200 -a ${result} -lt 300 ] then led_on 5 else led_on 1 fi elif echo "${line}" | grep -iq '^exit' then all_off exit 0 fi done